 |
 |
 |
|
|
|
[Sponsors] | ||||
June 14, 2014, 20:03
|
How to run cold flow in reactingFoam?
|
#1 |
|
New Member
Harshad Lalit
Join Date: May 2013
Posts: 26
Rep Power: 12  |
Hello all,
I have just started using OpenFoam for my dissertation on jet flame calculations. I am trying to simulate axisymmetric cold flow in reactingFoam. I switched off chemistry and reactions in the "constants" folder to simulate cold flow. Is that the correct way to go about doing it ? Also even if I switch off my chemistry, i still have default product species H2O and CO2 as output files. Why is that? Would really appreciate any help. Thanks 
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Unable to run lid-driven cavity flow with 1M elements | dougalb | OpenFOAM Running, Solving & CFD | 2 | April 6, 2019 23:34 |
| flow over a cylinder urgent! | kevin | FLUENT | 8 | August 11, 2015 13:00 |
| Cold FLow analysis in Gas Turbine..Help Needed | juzer_700 | FLUENT | 8 | September 30, 2013 02:47 |
| ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 15:45 |
| good Cold Flow Results but problem with Hot Flow | Rams | FLUENT | 1 | June 18, 2006 19:59 |
Threaded Mode
