|
[Sponsors] |
September 17, 2014, 23:03 |
simpleFoam & pimpleDyMFoam jump on fields
|
#1 |
Senior Member
|
Hi all,
I ran the same case with different solvers, it's similar to the 2Dmixervessel tutorial, but 3D. To obtain the mesh, I merged stator and rotor cellZones and defined AMI patches at interface. I ran once using pimpleDyMFoam and I had pressure and velocity field with no jump across AMI interfaces. If I run the case using simpleFoam with fvOptions, I see a jump on both fields across the surface. Why? Is there a way to smooth this? Here's a picture of the simpleFoam case. https://www.dropbox.com/s/r0lupkk4buqkwof/p.png?dl=0 |
|
September 17, 2014, 23:07 |
|
#2 |
Senior Member
|
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
From simpleFoam to pimpleDyMFoam | gregjunqua | OpenFOAM Running, Solving & CFD | 0 | May 6, 2014 20:48 |
a reconstructPar issue | immortality | OpenFOAM Post-Processing | 8 | June 16, 2013 11:25 |
an odd(at least for me!) reconstructPar error on a field | immortality | OpenFOAM Running, Solving & CFD | 3 | June 3, 2013 22:36 |
PostChannel | maka | OpenFOAM Post-Processing | 5 | July 22, 2009 09:15 |
write nut fields in simpleFoam | maurice | OpenFOAM Running, Solving & CFD | 5 | March 23, 2009 01:57 |