 |
 |
 |
|
|
|
[Sponsors] | ||||
November 14, 2014, 13:09
|
nozzle boundary conditions
|
#1 |
|
New Member
Marc
Join Date: Nov 2014
Location: Barcelona, Catalonia (still Spain)
Posts: 7
Rep Power: 11  |
Hello everyone!
I am working on a 3D nozzle and I am not capable of setting the BC in order to make the stream "flow". I am trying fixing a pressure at the inlet and a lower one to the outlet and I want to get the velocities associated. So, which are the proper BC to be set? Are them pressureInletOutletVelocity, freeStream or any other similar to these? in case they are, how should I program them in p and/or U files? Thank you very much  PS: before using the solver for compressible flow I am solving it with simpleFoam just to adjust rightly basic parameters; mainly p and U |
|
|
|
|
| Tags |
| boundary condition p, boundary condition u, boundary conditions, simplefoam |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Boundary Conditions for Podded Engine | ferocity | CFX | 2 | October 28, 2013 16:43 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
| Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 00:00 |
| Fluent accuracy and boundary conditions | Paolo Lampitella | FLUENT | 0 | June 12, 2008 06:25 |
| A problem about setting boundary conditions | lyang | Main CFD Forum | 0 | September 19, 1999 18:29 |
Threaded Mode
