 |
 |
 |
|
|
|
[Sponsors] | ||||
|
|
April 1, 2015, 18:33
|
RenumberMesh causing divergence
|
#1 |
|
New Member
anonymous
Join Date: Apr 2015
Posts: 4
Rep Power: 11  |
Hi,
I am running a flow past a cylinder case in 3D in openfoam. The case runs fine without RenumberMesh utility but I wanted to use RenumberMesh utility to speed up the solution. When I use the RenumberMesh utility, the solution diverges (mainly omega, I am using k-omega SST model). Is there any particular reason for this? P.s. When I used renumberMesh on the same case in 2D, everything ran fine. Thanks in advance. |
|
|
|
|
 |
| Tags |
| openfoam, renumbermesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Floating Point Exception Error | nyox | FLUENT | 11 | November 30, 2018 12:31 |
| [ANSYS Meshing] Help with element size | sandri_92 | ANSYS Meshing & Geometry | 14 | November 14, 2018 07:54 |
| Divergence problem | Smaras | FLUENT | 13 | February 21, 2013 05:03 |
| 3d vof | Smaras | FLUENT | 2 | February 19, 2013 06:58 |
| Dynamic Grid Remeshing causing Divergence? | Andrew Wick | FLUENT | 0 | January 23, 2006 18:39 |
Hybrid Mode
