|
[Sponsors] |
![]() |
![]() |
#1 |
Senior Member
CFD
Join Date: Nov 2010
Location: United States
Posts: 243
Rep Power: 17 ![]() |
Hello Foamers,
I hope that you are all well. I am doing a simulations on OpenFoam, specifically C-D nozzle with shroud. I have created the mesh using SnappyHexMesh and setup all required boundary conditions. Now, I am only left with selecting the proper solver for my case. I have run too many cases in simpleFoam, but never dealt with unsteady cases before. My question is which the proper solver for unsteady cases? Can some one share an example in OpenFoam that can handle unsteady problems? I would be really appreciate any help in this subject. Thanks in advance, |
|
![]() |
![]() |
![]() |
![]() |
#2 | |
Senior Member
Troy Snyder
Join Date: Jul 2009
Location: Akron, OH
Posts: 220
Rep Power: 19 ![]() |
Quote:
steps in a mixed PISO/SIMPLE mode. Take a look at the pitzDaily tutorial for case setup example. |
||
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Frequently Asked Questions about Installing OpenFOAM | wyldckat | OpenFOAM Installation | 3 | November 14, 2023 11:58 |
Is Playstation 3 cluster suitable for CFD work | hsieh | OpenFOAM | 9 | August 16, 2015 14:53 |
Suggestion for a new sub-forum at OpenFOAM's Forum | wyldckat | Site Help, Feedback & Discussions | 20 | October 28, 2014 09:04 |
Can not run OpenFOAM in parallel in clusters, help! | ripperjack | OpenFOAM Running, Solving & CFD | 5 | May 6, 2014 15:25 |
Case can't run continuously in OpenFOAM? | wzx1989221 | OpenFOAM Running, Solving & CFD | 2 | March 17, 2014 08:01 |