|
[Sponsors] |
Error on chtMultiRegionFoam compared to the chtMultiRegionSimpleFoam |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 1, 2016, 08:17 |
|
#3 |
New Member
flanel
Join Date: Apr 2016
Posts: 8
Rep Power: 10 |
Ok..problem solved... always check the geometrie... it was a 34m long tube instead of an 34mm short duct...
|
|
Tags |
chtmultiregionfoam, chtmultiregionsimpefoam, heat flux, temperature |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error in thermophysical properties (chtMultiRegionFoam) | mukut | OpenFOAM Pre-Processing | 28 | November 23, 2021 06:34 |
Error in chtMultiRegionFoam | michael157 | OpenFOAM Running, Solving & CFD | 17 | May 22, 2017 03:32 |
[snappyHexMesh] snappyHexMesh and cyclic boundaries | Ruli | OpenFOAM Meshing & Mesh Conversion | 2 | December 9, 2013 06:51 |
Embed explicitSetValue in chtMultiRegionFoam | samiam1000 | OpenFOAM | 2 | April 18, 2012 05:14 |
Multiregion Heat Transfer + natural convection (water) with chtMultiRegionFoam | fattychickenrun | OpenFOAM | 5 | October 31, 2011 16:53 |