|
[Sponsors] |
September 5, 2016, 11:24 |
Floating point exception Error
|
#1 |
Senior Member
ali
Join Date: Jul 2016
Posts: 147
Rep Power: 9 |
Hi All, I am a new user of OpenFOAM software. I created the mesh with GAMBIT software and I'm trying to solve my case with MPPICFoam solver. It is solved up to iteration of step 3 but after it the following error was created:
Error: mpirun noticed that process rank 7 with PID 9554 on node ubuntu exited on signal 8 (Floating point exception). Also, the error is attached by this email. Please help me. Thanks |
|
September 6, 2016, 06:09 |
|
#2 |
Senior Member
Join Date: Sep 2010
Posts: 226
Rep Power: 16 |
Hi,
can you show us all the 3 iteration results ? |
|
September 6, 2016, 13:43 |
Reply to T.D.
|
#3 |
Senior Member
ali
Join Date: Jul 2016
Posts: 147
Rep Power: 9 |
Ok thanks. I am sorry! because I have had a Iteration! that its steps are attached by this reply...
|
|
September 6, 2016, 13:49 |
|
#4 |
Senior Member
ali
Join Date: Jul 2016
Posts: 147
Rep Power: 9 |
the final image of the error... also I solved it with 8 subdomains.
did you see this kind of error before? Thanks in advance. |
|
September 7, 2016, 22:51 |
Help...
|
#5 |
Senior Member
ali
Join Date: Jul 2016
Posts: 147
Rep Power: 9 |
Hi All, Where is someone that help me??
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 13:21 |
Undeclared Identifier Errof UDF | SteveGoat | Fluent UDF and Scheme Programming | 7 | October 15, 2014 07:11 |
[General] 2 datas on one plot | Akuji | ParaView | 46 | December 1, 2013 14:06 |
Floating point error and divergence detected | aannjj | FLUENT | 0 | July 2, 2013 03:44 |
[Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 02:27 |