|
[Sponsors] |
March 29, 2018, 01:29 |
printstack error caused by subsetMesh error
|
#1 |
Member
Join Date: Jan 2018
Location: Malaysia
Posts: 58
Rep Power: 8 |
Hi everyone, I faced printstack error when running pimpleFoam. I saw some posts said that it may be caused by division of 0 but I didn't set 0 value for any fields except nut.
Attached is link of my input files. https://www.dropbox.com/sh/ea5auq83u...9ZzX7N7Sa?dl=0 This probably caused by bad mesh. So I checkMesh but the result is ok and last time step showed fail 1 mesh. However, foamToVTK showed that my cellSets, eg: carExtCS (a hollow box) is ok before that. But it became inappropriate after subSet Mesh. Attached picture is cellSet carExtCS before and subsetMesh carExtCS b4 subsetMesh.png carExtCS aft subsetMesh.png May I get some help on this? How should i subsetMesh to delete unwanted region to make a hollow space within my domain? Thanks a lot for your time to read through this Below is the output when run simulation https://www.dropbox.com/s/xu4hljpr7l...blockMesh?dl=0 |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM.org] compile error in dynamicMesh and thermophysicalModels libraries | NickG | OpenFOAM Installation | 3 | December 30, 2019 00:21 |
[blockMesh] blockMesh with double grading. | spwater | OpenFOAM Meshing & Mesh Conversion | 92 | January 12, 2019 09:00 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 09:17 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |