 |
 |
 |
|
|
|
[Sponsors] | ||||
June 16, 2018, 09:06
|
Flow over a duct multiple error
|
#1 |
|
New Member
deniz
Join Date: Apr 2012
Posts: 1
Rep Power: 0  |
Hi,
I am not very familiar with openFoam. I want to run a case which is attaced. There is a duct geometry and i want to see the solution. But at this phase; method, boundary conditions and values are not important. I just want to see the case running even if the results are not logical. Mesh is so course and boundary condition names are matched. But i have some errors in boundary condition files. Can you show me a way, help or any similar case in order to just run the simulation case? Attached files are below. As i mentioned values or results are not important, just want to see this case is running. Thanks in advance. 
|
|
|
|
|
 |
| Tags |
| multiple error |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DPM udf error | haghshenasfard | FLUENT | 0 | April 13, 2016 07:35 |
| [OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 20:43 |
| Compiling dynamicTopoFvMesh for OpenFOAM 2.1.x | Saxwax | OpenFOAM Installation | 25 | November 29, 2013 06:34 |
| [swak4Foam] installing funkySetFields | igo | OpenFOAM Community Contributions | 1 | November 20, 2012 21:16 |
| Ansys Fluent 13.0 UDF compilation problem in Window XP (32 bit) | Yogini | Fluent UDF and Scheme Programming | 7 | October 3, 2012 08:24 |
Linear Mode
