|
[Sponsors] |
July 5, 2018, 19:39 |
PimpleDyMFoam with groovy bc
|
#1 |
New Member
wiki
Join Date: Apr 2017
Posts: 3
Rep Power: 9 |
Hi all,
Good day everyone, I am simulating flow past circular cylinder with periodic blowing and suction from the top and bottom surface of the cylinder. In order to implement blowing and suction, i am using groovybc for the cylinder wall with mathematical expression,i.e vel_n=sin(2pi*f*t)*Gaussionfunction*sin(2pi*z/Lz). where vel_n is normal to surface velocity and Lz is spanwise domain length. I want to simulate VIV with openfoam with this blowing and suction from the cylinder wall. I used pimpleDyMFoam for VIV with rigidbodysixdofsolver in openfoam. The sixdofsolver specifies the boundary type of movingwallvelocity for the cylinder surface and does not allow to provide groovybc additionally for the same wall. I want to give both boundary conditions,i.e. groovybc and movingwallvelocity to the same patch,i.e. cylinder surface. I would appreciate help for cfd community. regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
pimpleFoam Vs pimpleDyMFoam -- Different Results | kingmaker | OpenFOAM Running, Solving & CFD | 1 | April 22, 2017 02:05 |
Access pointDisplacement field from within pimpleDyMFoam | paul b | OpenFOAM Programming & Development | 0 | December 2, 2016 03:16 |
Savonius pimpleDyMFoam | vitokad | OpenFOAM Pre-Processing | 10 | September 16, 2014 09:30 |
pimpleDyMFoam issue | giovanidiniz | OpenFOAM Running, Solving & CFD | 1 | July 5, 2013 07:25 |
pimpleDyMFoam | samiam1000 | OpenFOAM | 2 | September 19, 2012 10:11 |