|
[Sponsors] |
July 14, 2018, 11:18 |
Problem in overset postprocessing
|
#1 |
New Member
Adrien
Join Date: Nov 2014
Posts: 6
Rep Power: 11 |
Hi all,
I've run the simpleRotor case using overPimpleFoam solver. Everything is fine during the calculation. However, I have an issue when I want to display the results in paraview (see attached picture). I think it's an issue in Paraview but I am not sure. Do you have idea? Thank you, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 21:50 |
OF v1706: Problem with Overset | Flo_Ha | OpenFOAM Running, Solving & CFD | 20 | March 16, 2021 04:02 |
Overset mesh issiue | engineer_1993 | STAR-CCM+ | 3 | July 25, 2017 14:46 |
[OpenFOAM] Problem postprocessing decomposed case with 'paraFoam -builtin' | bentkj | ParaView | 4 | February 21, 2017 04:22 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |