 |
 |
 |
|
|
|
[Sponsors] | ||||
How to trigger a "dump" while the simulation is running? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 19, 2018, 06:52
|
How to trigger a "dump" while the simulation is running?
|
#1 |
|
New Member
mabedan
Join Date: Nov 2018
Posts: 1
Rep Power: 0  |
I'm interested in being able to dump a frame for postprocessing while the simulation is running, outside the predefined "write interval" in the config. Is that possible at all?
|
|
|
|
|
|
November 19, 2018, 07:38
|
|
#2 |
|
Senior Member
Robert
Join Date: May 2015
Location: Bremen, GER
Posts: 292
Rep Power: 11 |
Solution one: Change your writeInterval so it writes a save as soon as possible and then change again to your larger timestep.
Solution two: Use stopAt writeNow; [Link]. This stops the simulation and writes a timestep. You will have to restart the simulation afterwards.
__________________
If you liked my answer to your question, please consider leaving a "Like" in return 
|
|
|
|
|
|
|
| Tags |
| post processing, write control |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| a transient cfx simulation suddenly stopped writing .out and then .bak while running | mona.li | CFX | 1 | March 5, 2018 04:15 |
| Help running SST k-omega Stress-Blended Eddy Simulation | DA6righthand | FLUENT | 0 | July 15, 2017 10:44 |
| Crashed user libraries due to compiling them while running a simulation | juhuettn | OpenFOAM Programming & Development | 1 | June 3, 2015 09:22 |
| Steps to be completed before running the simulation | Saha_AIT | STAR-CCM+ | 3 | December 1, 2009 10:54 |
| Replacing mesh while running a simulation | akultane | CFX | 1 | November 15, 2009 13:46 |
Linear Mode
