|
[Sponsors] |
Issue with inlet boundary condition (SurfaceNormalFixedValue) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 29, 2019, 09:49 |
Issue with inlet boundary condition (SurfaceNormalFixedValue)
|
#1 |
New Member
Lauren Johnston
Join Date: Mar 2019
Posts: 16
Rep Power: 7 |
Hi,
I have run a steady simulation on a geometry using SurfaceNormalFixedValue as the inlet boundary type: inlet { type surfaceNormalFixedValue; refValue uniform -0.1218; //neg. so that flow is into the model //0.1218 m/s } However when checking the inlet velocity in paraview there seems to be a section of much higher velocity at the corner of the inlet (see attached picture). steady_surf_normal_inlet_internal_mesh.jpg steady_surf_normal.jpg Any ideas? Lauren |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Acoustic boundary condition with pressure perturbation at inlet | hand90 | CFX | 2 | August 10, 2018 07:36 |
CFD analaysis of Pelton turbine | amodpanthee | CFX | 31 | April 19, 2018 18:02 |
Time dependant pressure boundary condition | yosuke1984 | OpenFOAM Verification & Validation | 3 | May 6, 2015 06:16 |
get edge points for inlet boundary condition | pastilha | OpenFOAM Programming & Development | 2 | May 7, 2013 03:05 |
Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 00:00 |