|
[Sponsors] |
Inviscid compressible flow using rhoSimpleFoam |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 12, 2020, 04:19 |
Inviscid compressible flow using rhoSimpleFoam
|
#1 |
Member
ishan
Join Date: Oct 2017
Posts: 77
Rep Power: 8 |
Hello.
Is it possible to setup inviscid compressible simulation using rhoSimpleFoam ? I made the following changes to my setup to setup an inviscid case:
I have looked in the posts here but could not get complete information. Can someone please tell me should I make any more changes ? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Issues on the simulation of high-speed compressible flow within turbomachinery | dowlee | OpenFOAM Running, Solving & CFD | 11 | August 6, 2021 06:40 |
rhoSimpleFoam with specified mass flow rate at outlet | ishan_ae | OpenFOAM Running, Solving & CFD | 3 | September 1, 2020 01:11 |
VOF compressible two-phase flow | lzhaok6 | Fluent Multiphase | 0 | August 17, 2020 17:17 |
[rhoCentralFoam] simulating compressible inviscid flow | Yuval | OpenFOAM Running, Solving & CFD | 2 | January 27, 2016 21:33 |
Naca 0012 (compressible and inviscid) flow convergence problem | bipulsaha | FLUENT | 1 | July 6, 2011 07:51 |