[quarkz]

Hi,

I'm trying to run a Overset 3D mesh case. I used the fvScheme and fvSolution from the tutorials.

However, when I tried to run it, it crashes at the 1st time step. The output is shown below. In this case, there's no mesh motion and I'm using a steady state solver overSimpleFoam. Previously, I tried a 2D case and it worked.

Any suggestion?

Starting time loop

forces forces:
rho: rhoInf
Freestream density (rhoInf) set to 1.2
Not including porosity effects
forceCoeffs ForceCoeffs:
rho: rhoInf
Freestream density (rhoInf) set to 1.2
Not including porosity effects

Time = 1

smoothSolver: Solving for Ux, Initial residual = 1, Final residual = 0.00262235, No Iterations 3
smoothSolver: Solving for Uy, Initial residual = 1, Final residual = 0.00253801, No Iterations 3
smoothSolver: Solving for Uz, Initial residual = 1, Final residual = 0.00361835, No Iterations 3
--------------------------------------------------------------------------
An MPI process has executed an operation involving a call to the
"fork()" system call to create a child process. Open MPI is currently
operating in a condition that could result in memory corruption or