 |
 |
 |
|
|
|
[Sponsors] | ||||
November 3, 2018, 08:57
|
Doubts about twophaseeulerfoam
|
#1 |
|
New Member
krishnan
Join Date: Feb 2018
Posts: 16
Rep Power: 8  |
Greetings!!!
I have questions regarding twophaseeulerfoam. While performing euler-euler simulations on fluent, I see that for the continuous phase, there is no need to input the continuous phase diameter. TwophaseEulerFoam however requires this value. Is this because of the inclusion of the blending option to include phase inversion? What is a reasonable estimate for the continuous phase dia? For eg: in the bubblecolumn case, the water dia is 1e-4. If I need to perform a spray simulation (where air is the continuous phase), can I use the same value of 1e-4. Regards, |
|
|
|
|
|
June 15, 2021, 10:33
|
|
#2 |
|
Member
Lourenço SM
Join Date: Jul 2014
Location: Lisboa, Portugal
Posts: 40
Rep Power: 11 |
Have you found an answer?
regards, |
|
|
|
|
|
 |
| Tags |
| openfoam, phase diameter, phasproperties, twophaseeulerfoam |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| twoPhaseEulerFoam: sudden crash | hcen | OpenFOAM Running, Solving & CFD | 18 | September 29, 2020 03:04 |
| twoPhaseEulerFoam fluidized bed wrong results | FabianB | OpenFOAM Running, Solving & CFD | 0 | June 14, 2017 03:48 |
| Is twoPhaseEulerFoam applicable to 3D cases / delivering erroneous results? | ThomasV | OpenFOAM | 0 | November 11, 2013 08:10 |
| Something wrong in UEqns.H within twoPhaseEulerFoam | cheng1988sjtu | OpenFOAM | 2 | June 24, 2011 10:48 |
| twoPhaseEulerFoam | freemankofi | OpenFOAM | 0 | May 23, 2011 16:24 |
1Likes
Linear Mode
