|
[Sponsors] |
June 15, 2021, 23:09 |
Mesh refinement very diferent results
|
#1 |
New Member
Gustavo
Join Date: Jun 2021
Posts: 17
Rep Power: 4 |
Hello,
I am trying to simulate a stepped channel using the multiphase/interFoam/RAS/weirOverflow example as base. For the stepped channel, I created a .stl file and start to tests some refinaments around the channel with the snappyHexMesh tool (and after I used the extrudeMesh tool to run in 2D). If I use refinament levels (2 3), in the instant 2 seconds, the velocity magnitude is: If I use refinament levels (2 4), in the instant 2 seconds, the velocity magnitude is: The behavior in the two cases is very diferent. In the level (2 3) there are a air movement above the channel that I cant explain, while in the level (2 4) the water behavior is not what I expect. Someone knows why? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh sticking point | natty_king | OpenFOAM Meshing & Mesh Conversion | 11 | February 20, 2024 09:12 |
[snappyHexMesh] snappyHexMesh stuck when snap is turned on | yukuns | OpenFOAM Meshing & Mesh Conversion | 3 | February 2, 2021 13:05 |
[snappyHexMesh] Removing further cells after SHM | zonda | OpenFOAM Meshing & Mesh Conversion | 14 | September 15, 2017 07:50 |
[snappyHexMesh] SHM problem : KVLCC2 with appendage mesh | sc.park | OpenFOAM Meshing & Mesh Conversion | 1 | March 13, 2016 13:28 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |