|
[Sponsors] |
August 26, 2021, 17:38 |
Negative initial temperature error
|
#1 |
New Member
BC
Join Date: Jul 2021
Posts: 5
Rep Power: 4 |
SonicFoam, k-epsilon model and snappyhexmesh is used for 3D geometry. No matter how to change the mesh number, maxCo and delta T, the error still exists. Temperature limit is added in fvOption, but it didn't work. Anyone knows how to fix the problem?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
simpleFoam error - "Floating point exception" | mbcx4jc2 | OpenFOAM Running, Solving & CFD | 12 | August 4, 2015 02:20 |
Compressor Simulation using rhoPimpleDyMFoam | Jetfire | OpenFOAM Running, Solving & CFD | 107 | December 9, 2014 13:38 |
Undeclared Identifier Errof UDF | SteveGoat | Fluent UDF and Scheme Programming | 7 | October 15, 2014 07:11 |
pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 08:35 |
pisoFoam with k-epsilon turb blows up - Some questions | Heroic | OpenFOAM Running, Solving & CFD | 26 | December 17, 2012 03:34 |