[fxzf]

Originally Posted by arjun

Yes industrial cases could be tough. In fact this was the reason we wrote new software and not just used openfoam. For example the heat exchanger that i posted earlier had 6 regions and 11 interfaces. And this is first 3 calculations i did once the CHT model was added to the solver.

Yep, OpenFOAM has a great advantage based on its architecture. But if you want to do something over it, it would be pain. I would like to discuss the CHT problem with you. We can discuss through PM.

[arjun]

Originally Posted by fxzf

Yep, OpenFOAM has a great advantage based on its architecture. But if you want to do something over it, it would be pain. I would like to discuss the CHT problem with you. We can discuss through PM.

You can always send me a pm. However i am not that regular onn cfd online so might not immediately reply.