engineTime in OF-9 not writing out timesteps for specific configurations

mturcios777 · May 9, 2022, 16:43

Hello all,

I'm updating some old solvers up to OpenFoam-9, and an running into an issue with writing out timestep directories.

If I use writeControl of timeSteps, cpuTime, clockTime, everything works as expected. However, I want to write at a specific crank angle, so in the past I've used adjustableRunTime and set the adjustTimeStep to yes and this has worked out fine.

When running engineFoam/XiEngineFoam in OpenFOAM-9, this no longer outputs any timestep. I suspect this has to do with conversion from simulation time to crank angle. Has anyone else experienced this?

The tutorial kivaTest with XiFoam uses runTime and a non adjustable time step.

mturcios777 · May 9, 2022, 17:50

After some digging, I see that there was a fix pushed 5 months ago (I am using the downloadable source pack). The beginTime_ hadn't been set properly.

May 9, 2022, 16:43	engineTime in OF-9 not writing out timesteps for specific configurations	#1
mturcios777 Senior Member Marco A. Turcios Join Date: Mar 2009 Location: Vancouver, BC, Canada Posts: 740 Rep Power: 28	Hello all, I'm updating some old solvers up to OpenFoam-9, and an running into an issue with writing out timestep directories. If I use writeControl of timeSteps, cpuTime, clockTime, everything works as expected. However, I want to write at a specific crank angle, so in the past I've used adjustableRunTime and set the adjustTimeStep to yes and this has worked out fine. When running engineFoam/XiEngineFoam in OpenFOAM-9, this no longer outputs any timestep. I suspect this has to do with conversion from simulation time to crank angle. Has anyone else experienced this? The tutorial kivaTest with XiFoam uses runTime and a non adjustable time step.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] Contribution a new utility: refine wall layer mesh based on yPlus field	lakeat	OpenFOAM Community Contributions	58	December 23, 2021 02:36
SU2 7.0.7 Built on CentOS 7, parallel computation pyscript mpi exit error?	EternalSeekerX	SU2	3	October 9, 2020 18:28
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 05:38
[mesh manipulation] Importing Multiple Meshes	thomasnwalshiii	OpenFOAM Meshing & Mesh Conversion	18	December 19, 2015 18:57
[snappyHexMesh] crash sHM	H25E	OpenFOAM Meshing & Mesh Conversion	11	November 10, 2014 11:27

May 9, 2022, 17:50		#2
mturcios777 Senior Member Marco A. Turcios Join Date: Mar 2009 Location: Vancouver, BC, Canada Posts: 740 Rep Power: 28	After some digging, I see that there was a fix pushed 5 months ago (I am using the downloadable source pack). The beginTime_ hadn't been set properly.