[ZeinabM]

Hello All, I have run a full flow for a centrifugal pump and got the results. The pressure contours are so good as shown below. However, the velocity contours show zero velocity all over the pump. When I used Slice on ParaView, I found that the velocity has values on the impeller surface as I go through the depth which means that it's not zero all over the pump. What's interesting is that the pressure values are correct. I can't figure out why this is happening. My concern is that I am following a tutorial and the velocity contours are normal in his example. Any guess why this might be happening?

pressure.png
Pressure contours of my simulation.
velocity.png veolcity_tutorial.PNG
velocity contours of my simulation, and velocity contours of the tutorial.
slicevelocity.png
Velocity Contours of the slice


The tutorial I am following :

https://www.youtube.com/watch?v=MwgnOdizuG8&list=PLkKD7eCr9mpxhNAJFAU9NjKrECmcVsD3D&index=9