|
[Sponsors] |
August 12, 2022, 05:18 |
gas injection example
|
#1 |
New Member
Join Date: Jan 2022
Posts: 27
Rep Power: 4 |
hello!
i am beginner of openfoam. when i studied case of the gas injection in water, i had a question.. there are three inlets, and i applied to the named selection of three inlets equally with each other as "inlet" three inlets are separated each other, and the shape of three inlets are all circular shape, and the diameter is all same each other. if i want to releaseing the gas as 3 m/s in total, how i have to set the boundary condition of inlet? (1) is right? (2) is right? (1) boundaryField { inlet { type fixedValue; value uniform (0 3 0); } --> is this right? (2) boundaryField { inlet { type fixedValue; value uniform (0 1 0); } --> is this right? Thank you very much |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Setting the height of the stream in the free channel | kevinmccartin | CFX | 12 | October 13, 2022 21:43 |
Domain Reference Pressure and mass flow inlet boundary | AdidaKK | CFX | 75 | August 20, 2018 05:37 |
injection problem | Mark New | FLUENT | 0 | August 4, 2013 01:30 |
error message | cuteapathy | CFX | 14 | March 20, 2012 06:45 |
Gas pressure question | Dan Moskal | Main CFD Forum | 0 | October 24, 2002 22:02 |