Injection Flow rate -- CFD Online Discussion Forums

April 28, 2023, 08:17	Injection Flow rate	#1
Dorian90 New Member Dorian Join Date: Mar 2021 Posts: 10 Rep Power: 5	Hi Foamers, Please what is the difference between : Injection rate Qo = 5.00 × 10−4 m^2/s and Q1 = 5.00 × 10−4 m^3/s in OpenFoam? Also, is m^3/m/sec the same as m^2/s or m^3/s? Thank You for your help and guidance. Regards,

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
actual flow rate not match the designed flow rate in ventilation modeling	minecraftgp	OpenFOAM Running, Solving & CFD	2	November 18, 2018 12:37
mass flow inlet and pressure outlet with target mass flow rate	Zigainer	FLUENT	13	October 26, 2018 05:58
Flow rate restriction simulation set-up	siw	CFX	4	February 16, 2016 12:15
DPM injection mass flow rate	kingpots	ANSYS	0	November 22, 2012 11:12
Discrete Phase & Mass Flow Rate	MagnusZeus	FLUENT	0	December 2, 2011 17:57

All times are GMT -4. The time now is 17:16.