|
[Sponsors] |
May 22, 2023, 08:22 |
Emptying a bottle - Interfoam
|
#1 |
New Member
Asbjorn
Join Date: May 2023
Posts: 1
Rep Power: 0 |
Hello,
Im trying to set up a study where I empty a bottle with a hole in the top, to get air in, and one in the buttom there the fluid have to come out. The only force reacting on the fluid is gravity. I try to run the interFoam solver, but the deltaT keep getting smaller and smaller (I stopped it the it hit a e-14 value - see pic). I make the setup based on the damBreak tutorial. I do not make blockMesh because the bottle is round. I have not touched the fv.Solution other than trying to change the tolerances. Am I doing something totally wrong or am I just too impatient? I have attachted a picture of my p_rgh, U, alpha.water, transportProperties, a sketch of what i try to simulate and a screenshot of the solver when stopped. https://imgur.com/7BRRPmn |
|
Tags |
interfoam, vof model, vof multiphase, vof simulation |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
interFoam vs. simpleFoam channel flow comparison | DanM | OpenFOAM Running, Solving & CFD | 12 | January 31, 2020 15:26 |
problems at multiphase flows, emptying a bottle | mvo | CFX | 6 | February 29, 2016 09:28 |
k-e & GAMG interFoam Schemitisation Stability Issue | JFM | OpenFOAM Running, Solving & CFD | 3 | December 1, 2015 05:58 |
simulation of bottle emptying process | raki_mech81@yahoo.co.in | FLUENT | 6 | September 18, 2013 08:23 |
BC for emptying the bottle transient | nitin1685 | CFX | 1 | April 15, 2011 06:41 |