|
[Sponsors] |
mesh problem with layers on symmetry plane and edges not aligned |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
November 21, 2023, 10:06 |
mesh problem with layers on symmetry plane and edges not aligned
|
#1 |
New Member
Adam
Join Date: Nov 2023
Posts: 6
Rep Power: 2 |
Hello,
I use OpenFoam-2206, solver HiSA. I want to perform 3D external supersonic simulations for symmetric geometry, I want to do it for 1/4 of the system (geometry and computational domain). I set two patches as type "symmetryPlane;" but there were problem with layers on the end of computational domain - the layer disappears at the end of the computational domain. I changed patches from "symmetryPlane;" to "empty" and now layer is ok but I get this error with checkMesh: Code:
Number of edges not aligned with or perpendicular to non-empty directions Code:
boundary ( sym1YZ { type empty; faces ( (0 3 2 1) ); } sym2XZ { type empty; faces ( (0 1 5 4) ); } |
|
Tags |
symmetryplane |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh stuck when snap is turned on | yukuns | OpenFOAM Meshing & Mesh Conversion | 3 | February 2, 2021 14:05 |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
Extra edges or curves appearing while displaying Mesh on a created 'Plane' | vidyadhar | FLUENT | 2 | April 25, 2018 10:19 |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 07:41 |
[snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 10:03 |