|
[Sponsors] |
January 13, 2024, 16:06 |
Error when running pimpleFoam
|
#1 |
New Member
Vassilis
Join Date: Jan 2024
Posts: 3
Rep Power: 2 |
Hello everyone! i am having a hard time running the surfaceMountedCube case on openfoam2310.
Specifically, after running blockMesh i get the following error: FOAM FATAL ERROR: (openfoam-2312) Did not find a corresponding sourcePoint for every face centre From void Foam:ointToPointPlanarInterpolation::calcWeights (const pointField&, const pointField&) in file triSurface/triSurfaceTools/pointToPointPlanarInterpolation.C at line 155. FOAM exiting I have been scratching my head for a while... It would be amazing if someone had any ideas! |
|
Tags |
cfd, openfoam, pimplefoam, surfacemountedcube |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
pimpleFoam runs slower than rhoPimpleFoam | Kosuke Seto | OpenFOAM Running, Solving & CFD | 3 | May 27, 2023 14:12 |
pisoFoam and pimpleFoam are unstable in foam-extend 4.0/4.1 (misunderstanding ?) | Kombinator | OpenFOAM Running, Solving & CFD | 4 | January 14, 2021 04:10 |
Slow running of pimpleDyMFoam with respect to pimpleFoam. | gj11 | OpenFOAM Running, Solving & CFD | 2 | June 18, 2015 11:59 |
Segmentation fault when running in parallel | Pj. | OpenFOAM Running, Solving & CFD | 3 | April 8, 2015 08:12 |
Problem running IDDES with pimpleFoam | charlie | OpenFOAM Running, Solving & CFD | 7 | July 11, 2013 11:45 |