|
[Sponsors] |
March 16, 2024, 13:28 |
Bad Pressure Distribution
|
#1 |
Senior Member
Alan w
Join Date: Feb 2021
Posts: 264
Rep Power: 6 |
Hello,
In my efforts to debug my chtmultiregion case, I finally got it to create data! Then when I went to paraView, the pressure Distibution (see attached image) has an obvious problem, with high pressure at the inlet, and low pressure at the outlet, ignoring the body in the domain. I have been thrashing this for a couple of days, so far without luck. It could well be that someone amongst the community has seen this problem and found a fix for it; if so, could please! share your experience with me. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Suction pressure distribution at the bottom caused by a ship propeller | loewieke53 | OpenFOAM Running, Solving & CFD | 0 | April 6, 2020 06:41 |
outlet pressure Boundary settings -velocity streamline under ambient temp.conditions | Vishnu_bharathi | CFX | 12 | November 21, 2017 06:56 |
Pressure distribution | Tunlu | FLUENT | 0 | October 19, 2013 21:47 |
pressure distribution in water flow, differences in icoFoam and COMSOL | deniggo | OpenFOAM Running, Solving & CFD | 14 | September 30, 2010 03:48 |
Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 14, 2003 23:19 |