|
[Sponsors] |
Using OpenFOAM in microfluidics with second order slip on boundry layer |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 10, 2024, 15:19 |
Using OpenFOAM in microfluidics with second order slip on boundry layer
|
#1 |
New Member
Join Date: Dec 2023
Posts: 8
Rep Power: 2 |
Hello everyone.
I need to simulate a flow in a micro channel with Knudsen number=0.2. I must use these below second order velocity slip models for slip condition: I wanted to know is it possible to do this without writing new models? Is there any prepared model? Thanks in advance. C1 & C2 are the constants that are given. where U0 are boundary velocities from no slip solution and primes show the number of derivatives. |
|
Tags |
microchannels, slip boundary condition |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No generation of layer onto zerothickness surface | crubio.abujas | OpenFOAM Meshing & Mesh Conversion | 3 | October 25, 2022 03:20 |
[snappyHexMesh] Error defining boundary layer around cube snappyHexMesh | crizpi21 | OpenFOAM Meshing & Mesh Conversion | 5 | October 16, 2021 10:56 |
OpenFOAM v3.0.1 Training, London, Houston, Berlin, Jan-Mar 2016 | cfd.direct | OpenFOAM Announcements from Other Sources | 0 | January 5, 2016 03:18 |
Prismatic boundary layer | KateEisenhower | enGrid | 5 | September 15, 2015 07:48 |
Suggestion for a new sub-forum at OpenFOAM's Forum | wyldckat | Site Help, Feedback & Discussions | 20 | October 28, 2014 09:04 |