|
[Sponsors] |
September 3, 2008, 17:48 |
I have been trying to run a no
|
#1 |
Member
kshitij neroorkar
Join Date: Mar 2009
Location: Michigan, USA
Posts: 32
Rep Power: 17 |
I have been trying to run a nozzle test case using simpleFoam with FixedValue pressure at inlet and outlet boundaries and zeroGradient velocity at both boundaries. I am getting a strange acceleration zone at the exit of the nozzle due to a very high pressure cell.
I know that a better boundary condition is an outlet pressure and an inlet velocity condition but I donot have this information for this case. Could someone please tell me if I am applying some inconsistent boundary condition or does simpleFoam have a problem with sharp corners. I am attaching my case folder below for anyne who wishes to run it |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Courant no%23 and sharp corner in 3D | jam | OpenFOAM Running, Solving & CFD | 6 | November 18, 2008 08:21 |
Avoiding Skew in Tight Corners | Marc | FLUENT | 4 | July 23, 2007 15:21 |
Flow near sharp corners | Harish | Main CFD Forum | 4 | February 21, 2007 21:55 |
How to treat the 2D corners when using NSCBC? | leaf | Main CFD Forum | 0 | May 26, 2006 04:12 |
why the zones gets split at sharp corners/bends | Laxminarayana | FLUENT | 0 | February 16, 2005 02:13 |