[ali]

Has anybody implemented turbulent inflow conditions for DNS or LES of jets in openFOAM yet? I would be grateful if there is somebody who has done this and can share it. Is the mapping between the inlet and outlet of a pipe to get a fully-developed turbulent pipe flow a sufficiently accurate approach or it is not as good as the following inflow conditions?

I guess some of the good inflow conditions are as follow:

1) N. Jarrin, S. Benhamadouche, Y. Addad and D. Laurence
Synthetic turbulent inflow conditions for Large-Eddy Simulation ,
in Turbulence, Heat and Mass Transfer 4, Hanjalic, Nagano, Tummers Edts. Begell House inc., 467-474, 2003

2) M. Klein, A. Sadiki und J. Janicka A Digital Filter Based Generation of Inflow Data for Spatially Developing Direct Numerical or Large Eddy Simulations. J. Comp. Physics,186:652--665, 2002.