|
[Sponsors] |
February 17, 2010, 10:41 |
Exploding h/rho in rhoSimpleFoam
|
#1 |
Senior Member
BastiL
Join Date: Mar 2009
Posts: 530
Rep Power: 20 |
Dear Solver-Experts,
I am running a case in rhoSimpleFoam and I get exploding values for temperature and especially density after few iterations, but no divergence. This even happens for turbulence turned off. I have to blame a few cells in my prism layer (low-Re, layer next to wall) for this. I am trying to bound rho and h in some way, but without success so far. I tried: Code:
interpolationSchemes { interpolate(rho) limitedLimitedLinear phi 1.0 1.0 1.25; ... } Regards Last edited by bastil; February 17, 2010 at 10:59. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TRANSONIC FLOW in RHOSIMPLEFOAM | dinonettis | OpenFOAM Running, Solving & CFD | 10 | September 13, 2018 10:22 |
rhoSimpleFoam OF1.6 | sheintz | OpenFOAM | 4 | September 3, 2009 07:41 |
Monitor viscosity - RhoSimpleFoam | ABouvier | OpenFOAM Post-Processing | 5 | April 24, 2009 18:37 |
RhoSimpleFoam FoamX | spv24 | OpenFOAM Running, Solving & CFD | 1 | July 21, 2008 10:29 |
Stability startup problems with rhoSimpleFoam | olesen | OpenFOAM Running, Solving & CFD | 1 | July 18, 2006 08:09 |