|
[Sponsors] |
October 7, 2010, 02:35 |
|
#21 |
Senior Member
maddalena
Join Date: Mar 2009
Posts: 436
Rep Power: 23 |
||
October 7, 2010, 02:53 |
hi
|
#22 |
Senior Member
Join Date: Sep 2010
Posts: 226
Rep Power: 16 |
hi,
nothing connect them it is a free surface but in drawing it will be a cylinder where i must apply a certain BC on the outer side |
|
October 7, 2010, 03:19 |
|
#23 | |
Senior Member
maddalena
Join Date: Mar 2009
Posts: 436
Rep Power: 23 |
Quote:
This is only an idea. Maybe someone has more experience on the subject... mad |
||
October 7, 2010, 04:38 |
hi
|
#24 |
Senior Member
Join Date: Sep 2010
Posts: 226
Rep Power: 16 |
hi
lets consider from out it is closed wall my question was how to create the cylinder geometry in openfoam do i need to insert point point, it will be hard? how to draw? is there any software that i can draw in and then convert to blockMesh file? help please thanks a lot |
|
October 7, 2010, 04:44 |
|
#25 | |
Senior Member
maddalena
Join Date: Mar 2009
Posts: 436
Rep Power: 23 |
What??
If I am not wrong, you asked help for BC as well!!! Quote:
mad |
||
October 7, 2010, 06:10 |
ok
|
#26 |
Senior Member
Join Date: Sep 2010
Posts: 226
Rep Power: 16 |
ah ok thanks a lot
|
|
Tags |
boundary conditions, simulation cylinder |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
[ICEM] Problem with boundary layers for cylinder in channel | nik | ANSYS Meshing & Geometry | 0 | October 27, 2009 06:01 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Need help about boundary conditions for a francis runner flow simulation | Rodrigo Escobar Moragas | Main CFD Forum | 1 | October 26, 1998 08:20 |