|
[Sponsors] |
September 8, 2010, 13:26 |
Boundary Conditions. Simulation cylinder.
|
#1 |
Member
|
Hello! I just started with OpenFOAM.
I use version 1.7.0. I'm trying to simulate a cylinder in which the laminar (or turbulent) incompressible fluid flow. And the bottom of the cylinder rotates. Like this: What is the boundary condition I set on the bottom and how to do it? I would be grateful for any assistance conditional. Maybe someone has already done this? Sorry for my English A! And what solver shall i use? |
|
Tags |
boundary conditions, simulation cylinder |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
[ICEM] Problem with boundary layers for cylinder in channel | nik | ANSYS Meshing & Geometry | 0 | October 27, 2009 06:01 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Need help about boundary conditions for a francis runner flow simulation | Rodrigo Escobar Moragas | Main CFD Forum | 1 | October 26, 1998 08:20 |