 |
 |
 |
|
|
|
[Sponsors] | ||||
April 12, 2011, 18:48
|
axis symmetric + swirl
|
#1 |
|
New Member
Join Date: Apr 2011
Posts: 1
Rep Power: 0  |
Dear Foamers,
I am trying to simulate an steady, incompressible axis symmetric flow using simpleFoam (its flow in a ring pipe). The complication starts if i try to introduce swirl at the inlet. The swirl component of the flow is correct on the inlet but it doesn't get introduced into the flow. To verify my testcase as much as possible, i tried the full 3D geometry and it works. Can anyone help me out what can i possibly do wrong? (Does wedge support swirl?) Last edited by bthomas; April 12, 2011 at 18:49. Reason: oops, a typo unsteady -> steady |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [DesignModeler] axis display disparity of model and triad | ram881973 | ANSYS Meshing & Geometry | 14 | November 18, 2020 01:21 |
| Quantifying Swirl | Ianto | Main CFD Forum | 0 | April 27, 2009 10:54 |
| 2d axisymmetric with swirl | heather | OpenFOAM Running, Solving & CFD | 5 | July 28, 2005 17:20 |
| about axis symmetric cases | Masood | FLUENT | 3 | March 31, 2005 15:02 |
| Swirl in backflow on pressure outlets | Jonas Larsson | FLUENT | 17 | February 3, 2000 02:14 |
Linear Mode
