|
[Sponsors] |
July 14, 2011, 06:51 |
Basic question on motorBike tutorial
|
#1 |
New Member
Johan
Join Date: Jul 2011
Posts: 6
Rep Power: 15 |
Hi all,
I am very new to OpenFoam (and Linux) and I am trying to run the motorBike tutorial to get some basic insight. How does Allrun work? When I write Allrun and push enter I get Allrun: command not found What do I write to run all steps of the tutorial? Thankful for answers! |
|
July 14, 2011, 10:04 |
|
#2 |
New Member
Dima Risch
Join Date: Jun 2011
Location: Cologne
Posts: 22
Rep Power: 15 |
hi,
what linux do you use maybe following command could work ./Allrun if not, drag and drop Allrun into your terminal Allrun is a script file you can open with an editor regard, Dima |
|
July 14, 2011, 10:50 |
|
#3 |
New Member
Johan
Join Date: Jul 2011
Posts: 6
Rep Power: 15 |
Thank you!
|
|
Tags |
openfoam 2.0.x, openfoam introduction |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question from tutorial: Buoyant flow in a partitioned cavity | noppawit | CFX | 13 | March 19, 2014 03:18 |
[Gmsh] A basic Gmsh question: 1D transfinite | the_phew | OpenFOAM Meshing & Mesh Conversion | 0 | May 10, 2011 11:58 |
ensightToFoam error with motorBike tutorial | az_monger | OpenFOAM | 2 | August 17, 2009 15:45 |
Basic lagrangian Tutorial | jballen | OpenFOAM Running, Solving & CFD | 1 | August 23, 2005 08:27 |
natural convection tutorial question | Cynthia Campbell | FLUENT | 2 | June 29, 2001 20:09 |