|
[Sponsors] |
October 10, 2011, 14:13 |
rhoSimplecFoam, solving rho
|
#1 |
New Member
Jason
Join Date: Aug 2011
Posts: 10
Rep Power: 14 |
Hi,
I've got a problem with rhoSimplecFoam. I got a case which is quite similar to the squareBend in the tutorials but with symmetryPlanes on each side. My problem is, that although I copied all BCs, the solver won't solve rho. It says "rho max/min : 1 1" in each time step. But when I run squareBend it solves rho perfectly. Any ideas where my problem could be? Thanks a lot. Best regards Jason Edit: And I can't edit rho in any way, too. If I create a rho-BC the solver ignores it. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 11:16 |
IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 02:58 |
Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |