|
[Sponsors] |
August 6, 2012, 08:44 |
Hybrid mesh and unstable solution
|
#1 |
Member
|
Dear Foamers
Hi Recently, all of my simulations were blown out after 1 or 2 seconds. I use combination of hexahedral and tetrahedron meshes (hybrid meshes). Is the blowing out related to this? I checkmeshed and every thing is ok. Before that I used netgen3d for meshing and I didn't have any problem. After a lot of run, I believe that the problem definitely arise from the meshing. But I don't know how to deal with it. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Instability Vortex and Mesh Choice | kristapsb | Main CFD Forum | 2 | May 11, 2012 06:26 |
Unstable spray for small mesh size (dieselFoam) | namCFD | OpenFOAM | 2 | August 13, 2010 15:51 |
Asymmetry induced by the mesh | Ale | Main CFD Forum | 3 | December 14, 2007 14:44 |
small size cell problem(moving mesh) | Elyor | Siemens | 1 | May 12, 2007 23:45 |
Any mesh limitation for SSG Reynolds Stress Model? | Sam | Main CFD Forum | 1 | October 13, 2005 12:34 |