|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Anderson
Join Date: Feb 2013
Posts: 11
Rep Power: 13 ![]() |
Hi Friends
I have a solver for simulation low mach flow. I have some question about boundary condition. I want to simulate flame propagation in open tube. which boundary condition must I use for pd? I used zeroGradient for walls and inlet and fixValue(=1 atm) for outlet. but this boundary condition calculate pd about 1 atm whereas pd must be little than pReff. (pd<<pReff) and i thinck this is wrong. thanks alot |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
Anderson
Join Date: Feb 2013
Posts: 11
Rep Power: 13 ![]() |
no body
pleasssssssssss |
|
![]() |
![]() |
![]() |
![]() |
#3 |
Senior Member
n/a
Join Date: Sep 2009
Posts: 199
Rep Power: 16 ![]() |
I think you ought to use buoyantPressure boundary condition for pd.
|
|
![]() |
![]() |
![]() |
![]() |
#4 | |
Senior Member
Jianrui Zeng
Join Date: May 2018
Location: China
Posts: 157
Rep Power: 8 ![]() |
Quote:
|
||
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh file for flow over a circular cylinder | Ardalan | Main CFD Forum | 7 | December 15, 2020 13:06 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 10:37 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |