Propeller case in AMI tutorial - Page 2 -- CFD Online Discussion Forums

July 10, 2013, 16:12

Propeller case in AMI tutorial

reza1980

Member

reza

Join Date: Jan 2013

Location: Goteborg-Sweden

Posts: 79

Rep Power: 13

Hi Foamers,
I run the propeller case in AMI tutorial oF2.1x. One odd thing is the back flow on tip of blade and the non zero velocity in y-dir (flow dir) that not satisfy the no slip condition.(Please look the attachments)
I would like to know your comments.

The images are as below:

Attached Images

	1.jpg (46.4 KB, 436 views)
	2.jpg (43.7 KB, 337 views)
	3.jpg (40.7 KB, 322 views)
	4.jpg (41.2 KB, 314 views)
	5.jpg (39.4 KB, 253 views)

Last edited by wyldckat; April 30, 2017 at 11:00. Reason: merged posts done a few minutes apart

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
MRF and employing on a propeller case	reza1980	OpenFOAM	10	December 23, 2017 11:29
A questionable Tutorial test case	immortality	OpenFOAM Running, Solving & CFD	0	December 5, 2012 08:40
propeller tutorial	openfoam_user	OpenFOAM Running, Solving & CFD	0	February 8, 2012 04:02
tutorial copying troubles / new case	Gabbee90	OpenFOAM Running, Solving & CFD	0	June 3, 2011 21:50
FoamX refuses to open an interFoam tutorial case	vrecha	OpenFOAM Pre-Processing	5	March 12, 2008 12:36

All times are GMT -4. The time now is 07:36.