|
[Sponsors] |
How to specify the patch for yPlus calculation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 19, 2018, 17:18 |
How to specify the patch for yPlus calculation
|
#1 |
Senior Member
Join Date: Mar 2018
Posts: 115
Rep Power: 8 |
Hello everyone
I have an already finished simulation of flow around Naca 0012 airfoil inside a tunnel with k-wSST turbulence model. Can you please tell me how to calculate y+ for the airfoil ? is it possible to use this syntax: Code:
pimpleFoam -postProcess -func "yPlus(airfoil)" Another question, if I have many walls, and I want to calculate y+ only at a specific wall say the airfoil, how to proceed? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 15:33 |
Near wall treatment in k-omega SST | Arnoldinho | OpenFOAM Running, Solving & CFD | 38 | March 8, 2017 13:48 |
createPatch Segmentation Fault (CORE DUMPED) | sam.ho | OpenFOAM Pre-Processing | 2 | April 21, 2014 02:01 |
[blockMesh] Cyclic BC's: Possible face ordering problem? (Channel flow) | sega | OpenFOAM Meshing & Mesh Conversion | 3 | September 28, 2010 12:46 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |