[Dave110]

Hello,

I am trying to simulate spray mist cooling of hot plate which is at constant temperature 1073K. Injected water droplet is at 303K and surrounding air is also at 303K.

I am using sprayFoam to simulate this case. I have used following thermal spray models with coneNozzleInjection is used.

heatTransferModel --> RanzMarshall
phaseChangeModel --> liquidEvaporationBoil
atomizationModel --> LISA

Radiation is off.

Now, Problem is when water droplets hits the hot plate(wall), they should be heated up. But in current case setup, temperature of droplets decreased by 4 to 5 degree instead of heated up.

I can not understand why it happens? I am very close. can anybody help?

I am attaching configuration and droplet temperature.