 |
 |
 |
|
|
|
[Sponsors] | ||||
October 24, 2018, 06:37
|
different results by version 2.3.0 vs 3.0.0
|
#1 |
|
New Member
Not applicable
Join Date: Sep 2018
Posts: 15
Rep Power: 8  |
Dear Foamers,
I am calculating a case of cylinder flow. I am using DES(SA) in OpenFoam 3.0.0 but can't get a good result. There is a very interesting thing I found: I used the same grids, boundary conditions , fvsolution, fvscheme in openfoam2.3.0 and then I got a good result. I want to know why? I want to know the reason because I want to use WALE model in 3.0.0 which can not use in 2.3.0. my question: 1. what cause the difference between version 2.3.0 and 3.0.0? 2. Can I get the same DES results in 3.0.0 as in 2.3.0 by adjusting some thing? BEST |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem: Very long "write" time (~2h-3h) for results and transient results | Shawn_A | CFX | 16 | April 12, 2016 20:49 |
| OpenFOAM version 2.3.0 RPM on SuSE linux 12.2 | gautami | OpenFOAM Installation | 2 | May 25, 2014 11:37 |
| Adding temperature to interFoam, openFOAM version 2.3.0 | abdessamad | OpenFOAM Programming & Development | 0 | May 9, 2014 08:27 |
| Divergent temperature in chtMultiRegion(Simple)Foam | akrasemann | OpenFOAM Running, Solving & CFD | 13 | March 24, 2014 02:54 |
| How can i uninstall new version of OF | shipman | OpenFOAM Installation | 5 | August 12, 2013 04:01 |
Linear Mode
