 |
 |
 |
|
|
|
[Sponsors] | ||||
February 3, 2021, 03:56
|
fluentMeshToFoam not running
|
#1 |
|
New Member
Abolee
Join Date: Feb 2021
Posts: 1
Rep Power: 0  |
Hello, I'm totally new to openfoam and running my first tutorial(elbow). I have gone through many threads regarding this issue on internet but I'm still not getting it. Can anyone pls provide me solution for this. Here's the error what I get.
fluentMeshToFoam elbow.msh --> FOAM FATAL ERROR : Could not find mandatory etc entry (mode=ugo) 'controlDict' fluentMeshToFoam --help --> FOAM FATAL ERROR : Could not find mandatory etc entry (mode=ugo) 'controlDict' |
|
|
|
|
|
February 8, 2021, 07:38
|
|
#2 |
|
Super Moderator
Tobias Holzmann
Join Date: Oct 2010
Location: Tussenhausen
Posts: 2,708
Blog Entries: 6
Rep Power: 51   |
Which OpenFOAM version are you using? The version of ESI, FoamExtend, or The Foundation? The error message seems strange and hence, I believe anything went wrong during (a) installation or (b) compilation.
__________________
Keep foaming, Tobias Holzmann |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Simulation just stops output writing, but keeps running | blaise | OpenFOAM Running, Solving & CFD | 6 | March 27, 2024 04:49 |
| [swak4Foam] swak4foam openfoam 7 installation problem | Andrea23 | OpenFOAM Community Contributions | 1 | February 17, 2020 18:11 |
| Error problem while running sadia d lts tutorial | kane | OpenFOAM Running, Solving & CFD | 2 | May 26, 2018 03:38 |
| Error Running Design of Experiments in ANSYS Fluent | tytrzecki | FLUENT | 0 | April 22, 2018 15:01 |
| Problem in running coarse mesh(on the other hand fine mesh is running) | ashokmoravaneni | OpenFOAM | 7 | July 17, 2017 04:56 |
Linear Mode
