|
[Sponsors] |
December 5, 2019, 03:58 |
I'm getting error in nut file
|
#1 |
Member
Muhammad Kashif Jawad
Join Date: Oct 2019
Location: Pakistan
Posts: 48
Rep Power: 6 |
when i run the solver i get this error
i'm a newbie please help me. --> FOAM FATAL IO ERROR: expected keyword 'uniform' or 'nonuniform', found unifrom file: E:/Programs/blueCFD-Core-2017/ofuser-of5/run/waterChannel/0/nut.boundaryField.lowerWall from line 26 to line 20. |
|
December 5, 2019, 07:14 |
|
#2 |
Member
Join Date: May 2013
Posts: 34
Rep Power: 13 |
as the error message said, it is the spelling problem.
it should be 'uniform' but you write 'unifrom' in the file |
|
December 5, 2019, 08:36 |
|
#3 |
Member
Muhammad Kashif Jawad
Join Date: Oct 2019
Location: Pakistan
Posts: 48
Rep Power: 6 |
thanks Carye!!!!
you are right..this is the mistake... |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 09:46 |
[foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 22:53 |
[swak4Foam] Problem installing swak_2.x for OpenFoam-2.4.0 | towanda | OpenFOAM Community Contributions | 6 | September 5, 2015 22:03 |
"parabolicVelocity" in OpenFoam 2.1.0 ? | sawyer86 | OpenFOAM Running, Solving & CFD | 21 | February 7, 2012 12:44 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 12:46 |