|
[Sponsors] |
How to get the velocities corresponding to face/cell centers as output from a surface |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 21, 2020, 09:54 |
How to get the velocities corresponding to face/cell centers as output from a surface
|
#1 |
Senior Member
Arijit Saha
Join Date: Feb 2019
Location: Singapore
Posts: 132
Rep Power: 7 |
Hi, guys I have been trying to do some simulation in OF7 and there I noticed that it has really changed a lot since it s previous version.
So basically I was trying the pitzdaily tutorial and my aim is to get the output velocities of each face/cell and feed it as an input boundary of another pitz daily case setup. I have cut out a surface using surfaces dict and got the velocities but that corresponds to the vertex points. To make it clear lets say I have 30 cells and 62 vertex points so the velocity which are needed to be fed in the new simulation should be 30 in number corresponding to each cell and not 62. So, how can I get the output velocity corresponding to each cell/face in my first pitzdaily case setup? It will of great help if anyone responds to my thread. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Output data sets for each monitored surface | danielcollins | SU2 | 6 | March 29, 2022 10:25 |
[snappyHexMesh] Surface triangulation using snappyHexMesh | shaileshbg | OpenFOAM Meshing & Mesh Conversion | 4 | October 17, 2019 04:42 |
How To Create Fowcs William Hawkings Surface in Fluent? | marinkobezu | FLUENT | 7 | October 25, 2018 10:51 |
How to output boundary cells' information like centers and volume | keepfit | OpenFOAM | 0 | December 28, 2016 15:29 |
Free surface Velocities in the MAC based Methods | Maciej Matyka | Main CFD Forum | 6 | August 16, 2004 18:02 |