|
[Sponsors] |
September 4, 2020, 12:28 |
problem with facePostProcessing
|
#1 |
Member
Riddhideep Biswas
Join Date: May 2020
Posts: 30
Rep Power: 5 |
Hello foamers. I am simulating a sprayFoam case and I have applied stick condition to a wall so that particles, when they reach the wall, stick there.
I have also applied facePostProcessing on that wall to see how much mass is accumulated and the mass accumulation locations. But the facePostProcessing output shows an anomaly. It outputs that the mass accumulated is greater than the total mass that is injected (below I have attached figure). Why is this happening and how to rectify it? Last edited by -mAx-; September 22, 2022 at 02:19. |
|
Tags |
facepostprocessing, incorrect mass output |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SU2-7.0.1 on ubuntu 18.04 | hyunko | SU2 Installation | 7 | March 16, 2020 04:37 |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |