|
[Sponsors] |
October 22, 2021, 11:36 |
How to implement new thermotype?
|
#1 |
New Member
Join Date: Aug 2021
Posts: 3
Rep Power: 4 |
Hey everyone,
do you happen to know how to add a thermotype to the possible list of combinations? I have created the type thermo: hSolidLiquidPolynomial which is a copy of hPolynomial for testing. There are already a few threads on this topic e.g. Adding of a new thermotype but not for openfoam 9. An existing possible combination of thermotypes is: type heRhoThermo mixture pureMixture transport polynomial thermo hPolynomial equationOfState icoPolynomial specie specie energy sensibleEnthalpy When i change hPolynomial to my hSolidLiquidPolynomial I get the following error message. See attached screenshot. Does anyone know a solution to this, how to add custom thermotypes to the possible combination list? Thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to implement Regression Testing for CFD codes? | aerosayan | Main CFD Forum | 7 | July 5, 2021 10:08 |
How to change thermoType in reactingFoam (need to compile?) | KTG | OpenFOAM Programming & Development | 5 | September 3, 2020 08:25 |
slip & noslip boundary condition for dynamic mesh, how to implement? | oschi | OpenFOAM Programming & Development | 6 | May 21, 2019 04:33 |
Adding of a new thermotype | FlyingCat | OpenFOAM Programming & Development | 12 | February 18, 2019 07:39 |
How to implement a rigid lid aproximation for a 2d flow? | Jaydi_21 | Main CFD Forum | 0 | August 1, 2018 13:40 |