|
[Sponsors] |
January 10, 2023, 07:40 |
Meshing a previous sim
|
#1 |
New Member
California
Join Date: Dec 2022
Posts: 4
Rep Power: 3 |
Hello,
I am currently working on a laser powderbed fusion simulation, and would like some help in adding layers. Currently, I am using yade to simulate the powder settling on the previous melted layer. The current issue I am having is that OpenFOAM won't recognize the previous layer. I have extracted the mesh from paraview, but I do not know the proper process of making this mesh solid. The extraxted mesh is essentially a very complex sheet, without any good way of closing the mesh. Does anyone have any suggestions on how I would do this, or if there is a better approach? Best regards, Elbert |
|
Tags |
layers, lpbf, yade |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM.org] Problem installation OpenFOAM-dev | FlyingCat | OpenFOAM Installation | 15 | December 31, 2017 11:53 |
[ANSYS Meshing] Cooper Method Meshing | RTN3000 | ANSYS Meshing & Geometry | 1 | March 1, 2015 23:59 |
Meshing software comparison | Wikie | Mesh Generation & Pre-Processing | 5 | September 29, 2014 06:09 |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |