|
[Sponsors] |
February 13, 2024, 12:33 |
Boundary conditions for Scour
|
#1 |
New Member
Sonia
Join Date: Nov 2023
Posts: 2
Rep Power: 0 |
I created a scour case in sedFoam. i am confused about the BC
in blockmesh The BC for Inlet -patch Outlet-Patch Top-Patch Front-wall Front-Wall Bottom-wall I tried with cyclic bc for front and back. but now i want to run my case with wall bc for front and back. Then what are BC should I provide for epsilon, K.b , omega and nut.b of Front, Front, Bottom, Top. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
reverse flow in centrifugal fan blades | kalm | CFX | 20 | December 2, 2023 06:25 |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 07:30 |
Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 08:44 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |