|
[Sponsors] |
July 25, 2006, 03:12 |
Hello,
I'm having this prob
|
#1 |
Member
Fabian Peng Karrholm
Join Date: Mar 2009
Posts: 61
Rep Power: 17 |
Hello,
I'm having this problem with reconstructPar that I really can't figure out. I made a fresh OpenFOAM installation and did an Allwmake. As far as I can see there were no severe errors when doing the Allwmake, However, when I run reconstructPar on my case (which is binary uncompressed), I get: *** glibc detected *** double free or corruption (out): 0xb4cbb008 *** Since I never had problems with OpenFOAM 1.2, I went over the release notes, but couldn't find anything adressing this. This is on a 32-bit machine running Suse, kernel 2.6.13-15.11. I get a slightly different error message on a 64 bit machine (where the case is run), but it stops in the same place. On 64 bit I get: Foam::error::printStack(Foam:stream&) Foam::sigSegv::sigSegvHandler(int) /lib64/tls/libc.so.6 [0x392ce2e380] reconstructPar [0x464da1] reconstructPar [0x4669f2] reconstructPar [0x41be23] __libc_start_main __gxx_personality_v0 Any indication of where the error could be, would help. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bug in reconstructPar | david | OpenFOAM Bugs | 10 | May 26, 2009 12:11 |
ReconstructPar | kupiainen | OpenFOAM Post-Processing | 12 | April 21, 2009 01:47 |
[mesh manipulation] Error with reconstructPar | skabilan | OpenFOAM Meshing & Mesh Conversion | 3 | June 10, 2008 18:34 |
ReconstructPar | maka | OpenFOAM Bugs | 6 | August 22, 2007 04:23 |
ReconstructPar error | r2d2 | OpenFOAM Pre-Processing | 7 | September 12, 2006 09:37 |